N° 404
|
Måling af stifthøjde, huldybde og tandstørrelse på tandhjul Højden på en stift såvel som dybden på et blindhuls skal måles. Der ud over skal højden på tænderne på tandhjulet måles. Alle målinger skal foretages optisk.
Height measurement of a metal pin and of the teeth as well as the depth of a blind hole on a metal gear wheel
The height of a metal pin as well as the depth of a blind hole on a gear wheel should be controlled. Furthermore, the height of the teeth on the gear wheel should be measured.
|
|
N° 157
|
Skelne mellem håndtag med mat og højglans overflade Et mat krombelagt håndtag skal skelnes fra en krombelagt højglans håndtag.
Differentiation of a matt and a glossy chromate knob
A matt chromate knob should be differentiated from a glossy chromate knob.
|
|
N° 141
|
Positionscheck på skiver I plastkomponenter Orienteringen af skiver skal checkes. Kontrollen kan ikke foretages direkte ovenfra på grund af placering af andet udstyr.
Position monitoring of washers in plastic components
The orientation of washers (backside or front side above) should be checked. To control from the top (perpendicular to the surface) is not possible due to arrangement reasons.
|
|